Änderungen

Aus Linkerkit.de

Wechseln zu: Navigation, Suche

LK-Button2

138 Byte hinzugefügt, 14:31, 19. Okt. 2016
/* Codebeispiel Arduino */
==Codebeispiel Arduino==
<pre class="brush:cpp"> </pre>/Initialisiere LED auf Digital-PIN 6 und Buttons auf Digital-PINS 12 & 13int led = 6;int button1 = 12;int button2 = 13;
void setup() {
pinMode(button1, INPUT);
pinMode(button2, INPUT);
pinMode(led, OUTPUT);
Serial.begin(9600);
}
void loop() {
int sensorValue = digitalRead(button1);
int sensorValue2 = digitalRead(button2);
if(sensorValue==1){
digitalWrite(led, HIGH);
//Serial.println("High");
}
if(sensorValue2==1){
digitalWrite(led, LOW);
Serial.println("LOW");
}
}
 
</pre>
==Codebeispiel Raspberry Pi==
<pre class="brush:py">import RPi.GPIO as GPIO<br data-attributes="%20/" /><br data-attributes="%20/" /> #Initialisiere LED auf Digital-PIN 4 und Button auf Digital-PIN 15 & 16<br data-attributes="%20/" />led = 4<br data-attributes="%20/" />button1 = 15<br data-attributes="%20/" />button2 = 16 <br data-attributes="%20/" />GPIO.setwarnings(False)<br data-attributes="%20/" />GPIO.setmode(GPIO.BCM)<br data-attributes="%20/" />GPIO.setup(button1, GPIO.IN, pull_up_down=GPIO.PUD_UP)<br data-attributes="%20/" />GPIO.setup(button2, GPIO.IN, pull_up_down=GPIO.PUD_UP)<br data-attributes="%20/" />GPIO.setup(led, GPIO.OUT) <br data-attributes="%20/" />while True:<br data-attributes="%20/" /> if GPIO.input(button1) == GPIO.HIGH:<br data-attributes="%20/" /> GPIO.output(led, True)<br data-attributes="%20/" /> if GPIO.input(button2) == GPIO.HIGH:<br data-attributes="%20/" /> GPIO.output(led, False)</pre>
==Downloads==
Infos: [[Medium:001267833-da-01-en-linker_kit_platine_beschleun_bewegungs_.pdf]]
Schaltung: [[Medium:001267833-sp-01-en-linker_kit_platine_beschleun_bewegungs_.pdf]]
Von „https://www.linkerkit.de/index.php?title=Spezial:Mobiler_Unterschied/920...928“